Motion Control System
100 Series
|
|
|
|
|
This motion control system is stand-alone or externally
controlled, easy-to-use, plug-and-play and
cost effective solutions for
motion control applications.
Each system
includes the power supplies, controller,
the
micro-stepper and/or servo motor drivers.
and motors.
This motion control system supports up to 4 axes of
motion, 16 TTL / CMOS inputs, 16 TTL / CMOS outputs, 3 analog
inputs, and up to 5 optical encoder inputs. The command port is
provided for stand-alone operation.
The system
may be controlled in different ways;
1)
Stand-alone
In this mode, the controller does not need an
external device such as a PC to operate. The
controller is programmed in a simple programming
language. The code is developed, downloaded to the
controller, run and saved in the controller's
non-volatile memory using the supplied Integrated
Development Environment (IDE) software.
2)
Externally Controlled
In this mode, the external host such as a PC,
micro-controller or PLC sends a series of commands
to the controller via the RS-232 serial port. The
controller processes and performs the incoming
commands and responds with proper messages.
3)
Control Panel
The supplied user friendly Control Panel software
allows the user to set-up the module quickly. The
operator is able to move the mechanism to different
positions by pressing the corresponding buttons of
the Control Panel or by using the joystick and/or
trackball.
|
The system can also be operated using an
analog joystick or a trackball.
The speed of the
motor is
proportional to the tilt angle of the joystick
or the rotational
speed of the trackball.
|
Features
- Plug-and-Play
- Quick and Easy to Install
- Very Compact and Easy to Use
- Low Power Consumption, High Torque Motors, High Speed
Capability
- Easy Programming Language, No Compiler or Assembler
Required
- Programmable, Teachable or Manual Control
- Different Modes of Operation:
1) Host Controlled
2) Stand-alone, No PC Required to Operate
3) Joystick / Trackball Controlled
- Optical Encoder Feedback
- Available also to Drive DC Servo, Brushless, and Voice
Coil Actuators
- Totally Integrated Solution
|
Software
-
Easy System Setup and Evaluation
-
Menu Driven
- Free Software Included
|
|
Part No. |
Description |
Price |
|
100-1 |
Single-axis,
Programmable Motion Control System |
Call |
|
100-2 |
Two-axis,
Programmable Motion Control System |
Call |
|
100-3 |
Three-axis,
Programmable Motion Control System |
Call |
|
100-4 |
Four-axis,
Programmable Motion Control System |
Call |
Joy-3
picture |
Three-axis,
Pre-wired Joystick with 3 Speed Selection Keys |
$325.00
|
Joy-2
picture |
Two-axis, Pre-wired
Joystick with 3 Speed Selection Keys |
$225.00
|
TRKBL
picture |
Pre-wired Trackball |
Call
|
The pricing depends on the system configuration. Please contact
us for a prompt quotation. |
|
